Mounting Kit, control/trailing arm mounting
SuperPro Control Arm Lower-Inner Rear Bush Kit - Single Offset
Alignment Correction
Product Specifications:
- Components Per Product: 2B,2T,2S
There must be at least 30mm of clearance between the droop stop and the chassis at ride height to avoid any damage to the arms.
Use this kit to rectify a steering pull after a vehicle has been aligned to the manufacturer's specifications.
Supplied with an offset bush to be fitted to the passenger side and a standard bush for the driver's side, these kits stagger the caster or setback by repositioning the ball joint slightly forward in the chassis.
This is a non tyre wearing geometry change that has a substantial effect on a vehicles ability to track straight and other handling characteristics.
Follow the installation instructions and the problem is solved.
Vehicle Application Information:
- Steering Pull Correction Kit
- Fitting Position: Front
- Fitting time [min]: 180
- Axle alignment required after fitting
- Fitting Difficulty: difficult
- Axle alignment required after fitting
- Fitting Difficulty: difficult
- Fitting Position: Front