Front | Camber Adjusting Bolt Kit Adds +/- 1.5 Degrees camber | SPF4351-14K | 1 |  | $54.84 |
Kit, camber adjustmentCamber Adjusting Bolt KitAdds +/- 1.5 Degrees camber Camber Bolt Kit 14mm - Fitting Position: Front
- Fitting Position: Front
- Part of kit: (x)
|
Front | Control Arm Lower-Rear Bush Kit Standard Replacement | SPF3963K | 1 |  | $182.08 |
Mounting Kit, control/trailing arm mountingControl Arm Lower-Rear Bush KitStandard Replacement Standard Replacement - Axle alignment required after fitting
- Fitting Difficulty: difficult
- Fitting Position: Front
- Fitting Time [min.]: 180
- Part of kit: (x)
|
Front | Control Arm Lower-Rear Bush Kit - Double Offset
| SPF3965K | 1 |  | $182.08 |
Mounting Kit, control/trailing arm mountingControl Arm Lower-Rear Bush Kit - Double OffsetUse this kit to increase Caster for improved directional stability, turn in and control A Double Offset kit is used for enhanced handling performance and will deliver positive caster to both sides of the vehicle. The vehicle will have improved directional stability, crisper, more responsive steering and improved 'return to centre' feel. This is a non tyre wearing geometry change that has a substantial effect on a vehicles handling characteristics.
Follow the installation instructions and enjoy the results! Vehicle Application Information: - Axle alignment required after fitting
- Fitting Difficulty: difficult
- Fitting Position: Front
- Fitting Time [min.]: 180
- Part of kit: (x)
|
Front | Control Arm Lower-Rear Bush Kit - Single Offset
| SPF3964K | 1 |  | $182.08 |
Mounting Kit, control/trailing arm mountingControl Arm Lower-Rear Bush Kit - Single OffsetUse this kit to correct a slight pull Use this kit to rectify a steering pull after a vehicle has been aligned to the manufacturers specifications. Supplied with an offset bush to be fitted to the passenger side and a standard bush for the drivers side, these kits stagger the caster or setback by repositioning the ball joint slightly forward in the chassis.
This is a non tyre wearing geometry change that has a substantial effect on a vehicles ability to track straight and other handling characteristics.
Follow the installation instructions and the problem is solved. Vehicle Application Information: - Steering Pull Correction Kit
- Axle alignment required after fitting
- Fitting Difficulty: difficult
- Fitting Position: Front
- Fitting Time [min.]: 180
- Part of kit: (x)
|
Front | Sway Bar Link Cut To Length Link | TRC4004 | 2 |  | $42.32 |
Stabiliser Bar, chassisSway Bar LinkCut To Length Link 10mm Ball Joint Link
Minimum Length 80mm - Maximum Length 320mm - Fitting Difficulty: easy
- Fitting Position: Front
- Fitting Time [min.]: 30
- Part of kit: (x)
|
Front | Sway Bar Link Standard Replacement | TRC4022 | 2 |  | $36.95 |
Stabiliser Bar, chassisSway Bar LinkStandard Replacement 10mm Ball Joint Link
180 degree opposed
Length 250mm center to center - Fitting Difficulty: moderate
- Fitting Position: Front
- Fitting Time [min.]: 30
- Part of kit: (x)
|
Rear | Beam Axle Pivot Bush Kit
| SPF3984K | 1 |  | $225.16 |
Bush, beam axleBeam Axle Pivot Bush KitVehicle Application Information: - Fitting Difficulty: difficult
- Fitting Position: Rear
- Fitting Time [min.]: 240
- Part of kit: (x)
|